Walk through a modern flexo plant at changeover time and you will notice something: on press after press, the anilox comes off as a lightweight sleeve, not a heavy solid roller. There is a simple reason — sleeves have changed the economics of job changes.
A ceramic anilox sleeve is a laser-engraved ceramic anilox surface built on a lightweight carrier tube instead of a solid steel core. It slides onto the press mandrel (air shaft) and locks in place with air pressure. The printing surface — plasma-sprayed chromium oxide ceramic, laser engraved with precise cells — is the same proven technology as a solid ceramic anilox roller. What changes is everything around it.
Sleeve fit is unforgiving, so specifications matter more than with solid rollers. Confirm the mandrel diameter and the sleeve's inner diameter and wall construction, the repeat length, and the required face length. Then define the engraving as you would for any anilox: line count (LPI), cell volume (BCM/cm³), and cell geometry matched to your ink, substrate and print work. Finally, check total indicated runout (TIR) — a quality sleeve should run as true as a solid roller, or print quality will suffer at speed.
We laser-engrave ceramic anilox sleeves from 30 to 2000 LPI, with trihelical, open-channel and conventional cell geometries, engraved to your exact volume specification. Every sleeve is inspected before delivery and shipped with a cell volume report, so the sleeve that arrives is the sleeve you ordered — ready to slide on and print.
If your press runs on sleeves — or you are planning a sleeve-based press — send us your mandrel and engraving specifications. We are happy to quote to your exact requirements and share our spec sheet and reference cases.
Kunshan Qishen Laser Technology Co., Ltd. | Room 10, No.399 Cangye Road, Huaqiao Town, Kunshan City, Jiangsu, China | www.aniloxcylinder.com | WhatsApp +86 18295718941
Walk through a modern flexo plant at changeover time and you will notice something: on press after press, the anilox comes off as a lightweight sleeve, not a heavy solid roller. There is a simple reason — sleeves have changed the economics of job changes.
A ceramic anilox sleeve is a laser-engraved ceramic anilox surface built on a lightweight carrier tube instead of a solid steel core. It slides onto the press mandrel (air shaft) and locks in place with air pressure. The printing surface — plasma-sprayed chromium oxide ceramic, laser engraved with precise cells — is the same proven technology as a solid ceramic anilox roller. What changes is everything around it.
Sleeve fit is unforgiving, so specifications matter more than with solid rollers. Confirm the mandrel diameter and the sleeve's inner diameter and wall construction, the repeat length, and the required face length. Then define the engraving as you would for any anilox: line count (LPI), cell volume (BCM/cm³), and cell geometry matched to your ink, substrate and print work. Finally, check total indicated runout (TIR) — a quality sleeve should run as true as a solid roller, or print quality will suffer at speed.
We laser-engrave ceramic anilox sleeves from 30 to 2000 LPI, with trihelical, open-channel and conventional cell geometries, engraved to your exact volume specification. Every sleeve is inspected before delivery and shipped with a cell volume report, so the sleeve that arrives is the sleeve you ordered — ready to slide on and print.
If your press runs on sleeves — or you are planning a sleeve-based press — send us your mandrel and engraving specifications. We are happy to quote to your exact requirements and share our spec sheet and reference cases.
Kunshan Qishen Laser Technology Co., Ltd. | Room 10, No.399 Cangye Road, Huaqiao Town, Kunshan City, Jiangsu, China | www.aniloxcylinder.com | WhatsApp +86 18295718941